Articles
Mar 19, 2015
A little Hold Tight goes a long way — the recommended usage ratio is usually 100:1. Usually one gallon is plenty to rinse one car. For larger projects, we carry 5 gallon pails.
Mar 19, 2015
Hold Tight is easy to apply and works well in any standard pressure washer at 500 PSI. With no rain and at temperatures above 40 degrees, rusting will be prevented for about 48 hours, often longer.
Mar 19, 2015
Hold Tight is classified as non-hazardous, non-toxic , Biodegradable, Phosphate and acid-free, Non-flammable, and leaves behind no residue. This product can also be used in FDA and USDA regulated facilities and fully complies with 21 CFR 178.3400. When we ship out...
Mar 19, 2015
Although water can be used for rinsing purposes after soda blasting, Hold Tight 102 helps ensure all residue is removed from all surfaces, including hard to reach areas. Hold Tight is a wonderful “salt” and “chloride” remover, so using it can...
Mar 19, 2015
BOTH — Hold Tight can be used as an additive with slurry blasters and poured into the blast pot at the same time you are adding water and media. Hold Tight can also be used upon completion of blasting. A “post-blasting” rinse cycle is a quick and...